Information

Smart Cabrio

anything about the cabrio

Members: 191
Latest Activity: 2 hours ago

Discussion Forum

turn key, nothing

Started by denise fred olderr. Last reply by microenvy Sep 1, 2012. 1 Reply

Top not closing tight

Started by Richard Baker. Last reply by Richard Baker Oct 13, 2010. 3 Replies

panel scratches

Started by Rita. Last reply by Richard Baker Oct 13, 2010. 3 Replies

Comment Wall

Comment

You need to be a member of Smart Cabrio to add comments!

Comment by Itasca Mark on November 22, 2009 at 8:41pm
Keith,

Every time I hit a bump at 40 or more MPH...SQUEAK. On uneven, poorly poured concrete roads it was a series of squeaks. It drove me nutzzz.

When I took my cab in for the 10K service I asked them to listen for the squeak on the drivers side. They found it and fixed it (under warranty) by simply loosening up and retightening the fasteners of the top's frame. It took about 1.5 hours but was well worth it. No squawking from me!

Good luck with your squeak.
Comment by Diana & Gary on September 3, 2009 at 9:32am
Be sure you are putting your tail gate up after the top is in place, that will cause excess air noise in the back, because it doesn't completly close.
Comment by SMARTY on September 3, 2009 at 1:52am
Umm.... is my rooF suppose 2 RATTLE!? :-/ IM havN some vibrations rumbleN wen im drivN and shud i be hearing outside noise clearly in the back area, is this jus been a CAB :-? is ther anyone else to hav this issue!
Comment by Billc on August 20, 2009 at 3:58pm
Keith, I have your twin but have not had a problem with noise. I did however have the button fall in twice. I guess I just put to much pressure on the switch. I plan to wire mine so I don't have to have the key switch on to put the top up or down.
Comment by Keith got his smart on July 14, 2009 at 1:26pm
Does anyone know if any progress has been made on the "squeaky rib" issue with the soft top? I have found that sometimes if you put the top down and put it back up it doesn't squeak quite as much. Any thoughts?
Comment by Keith got his smart on June 29, 2009 at 12:15pm
Anyone else had a problem with the soft top button falling down inside the shifter console? Last week when I put the top down I may have put a bit more pressure in the button than ususal and it went through the top of the console. The top was down and I was going to be out of town for the next 3 days. Panic! I called the dealer but it was after 6 PM. To make a long story short, I was able to pry up the plastic plate that holds the button (the one with the PRND for the shifter) and the button was dangling from it. I snapped the button back in place and then snapped the plate back in place. The moral of the story is be careful how hard you push that button.
Comment by Keith got his smart on June 29, 2009 at 11:55am
Cleveland, OH area
Comment by Karen on June 25, 2009 at 8:58am
Central Virginia
Comment by LTL MOUS on June 24, 2009 at 2:51pm
I'm in Illinois.
Comment by Diana & Gary on June 23, 2009 at 10:02am
We're in Kansas, thinking about going back East in August for a Visit, Pennsylvania, Maryland, would be around the 15 of August.
 

Members (191)

 
 
 

find a

smart center

go

Photos

Loading…
  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2014   Mercedes-Benz USA, LLC.

Badges  |  Report an Issue  |  Terms of Service