Brabus007's Comments

Comment Wall (17 comments)

You need to be a member of smart USA insider to add comments!

Join smart USA insider

At 10:10am on September 6, 2010, GetSmrt28277 said…
if you really want one of the RC smarts, let me know. PM me and I'll send you my email address, then we chat how to get one to you.
At 7:58pm on December 20, 2009, John Stump said…
I usually use Office picture manager. I usually take pictures at a higher resolution for better quality even though it takes more memory. Doesn't resizing change the image quality?
John
At 5:11pm on December 20, 2009, John Stump said…
Thanks for the info on the photo sizes. I was unaware that they were too large as they seemed fine when I viewed them on my computer.
Merry Christmas to you & yours, John

PS: I like your selection for your smart's color ;-)
At 5:03pm on December 3, 2009, Randy Fuller said…
Hey did you like those pics I sent you regarding the fresh air pipe. It really works great if you can manage the fabrication. Let me know if you try it. Thanks, Randy Fuller.
At 2:47am on November 1, 2009, spicejax said…
Thanks! Now when I look at my little friend pix I'll know which one is you. It'll "Grab my eye". lol

Thanks, again
MJB
At 7:34pm on October 31, 2009, spicejax said…
Hey, Brabus 007. Put your 'Kompressor' photo on your profile. That old silhouette is boring. lol

MJB
At 4:46am on October 25, 2009, Zippin Pippin said…
did you have the A.C. problem with the sensor in the footwell issue? I saw your post on Dr. Alex's page. I had that problem as well. It certainly has the capacity to cool really well.
At 9:44pm on October 23, 2009, Ken Peterson said…
Brabus007 - No doubt about it there will be two of the best looking gas caps on a Smart. Best color too, white, only mine has the silver tridion. But, the cap just jumped at me.... thanks for sharing the instructions, I love it!!!
At 11:00am on October 23, 2009, Zippin Pippin said…
It is basically an off set value or boundary level that lets the scangauge know when the injectors are shut off during deceleration or coasting. There is a generic value suitable for most engines just like there is a generic beginning value of engine liter size of 3 liters, only 70% off in this case.
At 2:22am on October 23, 2009, Zippin Pippin said…
And it clicks and carries on when shutting off, too. So much for solid state. I am surprised at all of the relay clicks!
Are you using a scangauge II ? What do you use for the cutoff setting?
Thx in advance,
Rich
At 7:50pm on October 18, 2009, Zippin Pippin said…
I especially like the 6 clunks under the floor boards as I drive off from start up! It reminds me how smart this car is!
Rich
At 7:17pm on October 18, 2009, Zippin Pippin said…
I think the air injection pump sounds like a compressor at start up. I think that qualifies as a compressor. It VILL VERK! (German accent)
:)
At 2:08pm on October 18, 2009, spicejax said…
Just read your comment on Air vs Nitrogen. Good job. You saved me some money as my light also went off and I was going to go 'Nitrogen'. I was thinking that the bigger molecules would help the prevent 'leaking' (mmmm, Kool-Aid). I had forgot about the weather.

Thanks, MJB
At 11:33am on October 16, 2009, spicejax said…
Classy, I LIKE it!
At 2:40am on October 16, 2009, spicejax said…
Is that "kompressor" down on the right side?
At 9:41pm on October 15, 2009, spicejax said…
What's up OCALA! Jacksonville in da house!

I saw your photos of Smarty Pants on the comment you made to 'ranting' ROB. Very nice, stylish MB look. Well done. Exhaust looks much better than the "Brabus" type, could fool folks to think it's a real dual.

Post them pix on your page, your cupboard is bare. lol
MJB
At 1:40am on September 8, 2009, SMARTY said…
hav any pics of your smart?

find a

smart center

go

Photos

Loading…
  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2014   Mercedes-Benz USA, LLC.

Badges  |  Report an Issue  |  Terms of Service